It’s a nice gentle shape, really light weight with well made parts that work really well.
I use it for all of the typical bow saw tasks like sawing curves, pierced work and the like. I soon realized it was also perfect for waste removal. Using the bow saw much the same choice you would a fret saw or maybe a coping saw removing the waste in dovetails.
Not so long ago I took it apart for transport and when I reassembled it and put tension back on the bow-
SNAP !
; (
Damn…alchoices right in the middle of a project isn’t it?
Well, I better fix it.
Nothing fancy, no time for that, just a quick fix with some quarter sawn Ontario white oak.
The straight grain will be perfect for this application.
It went something like this…
this is the worst noise ever- the crack of hickory.
On an off cut of white oak I trace the one good arm.
scribe the width and grab my favorite rip saw.
check for length and scribe.
clean and square with the jack plane.
x-cut at the bench with 14" back saw.
the top tapered area is marked.
mark the mortise location and drill for turned handle pin.
brad point bit exact width of mortise.
two chisels- exact width and length of mortise...
makes for quick work.
x-cut profile- saw kerf establish depths.
bust out the waste and quickly clean with rasp and file.
back to work !
0 komentar:
Posting Komentar